NordicTrack 1300 Elliptical - Page 8

8
5
5. Identify the Right Pedal Plate (107), which is
marked with an “R” sticker.
Attach the Right Pedal Plate (107) to the Right
Pedal Arm (8) with three M10 x 20mm Patch
Screws (108) and three M10 Split Washers
(
110).
Repeat this step on the other side of the
elliptical exerciser.
1
08
107
8
110
6
6. Identify the Right Pedal Assembly (62), which is
located in a package marked with a “Right”
sticker.
Attach the Right Pedal Assembly (62) to the
Right Pedal Plate (107) with five #10 x 1/2"
Screws (79), five M6 Split Washers (111), and
five #10 Fender Washers (80). Tip: There are
eight holes around the Right Pedal Plate;
only five holes will be used. To avoid dam-
aging the Right Pedal Assembly, do not
overtighten the Screws.
Repeat this step for the other side of the
elliptical exerciser.
80
Do not use
these holes
62
107
79
79
111