NordicTrack 1300 Elliptical - Page 9

9
7. Identify the Right Link Arm (10), which is
marked with a “Right” sticker.
A
pply a small amount of grease to the two axles
on the Right Link Arm (10) and to two 5/8"
W
ave Washers (102). Then, slide a Pivot
Spacer (71) and a Wave Washer onto each
axle.
Gradually work the Right Link Arm (10) into the
right Upper Body Arm (12) while at the same
time working the Right Link Arm into the Right
Pedal Arm (8).
Tip: These parts are designed to fit tightly. It
may be helpful to move the Right Pedal Arm
(8) while working these parts into place.
Repeat this step for the other side of the
elliptical exerciser.
7
10
12
71
102
8
Grease
Grease
102
71
8. Attach the Right Link Arm (10) to the right
Upper Body Arm (12) with a 5/16" x 1" Patch
Screw (81), a Large Axle Cover (94), and a
5/16" Washer (104).
Then, attach the Right Link Arm (10) to the
Right Pedal Arm (8) with a 5/16" x 1" Patch
Screw (81), a Small Axle Cover (67), and a
5/16" Washer (104).
Tip: If it is difficult to work the Right Link
Arm (10) into the right Upper Body Arm (12)
and the Right Pedal Arm (8), try working the
Right Link Arm in halfway and then tighten-
ing the 5/16" x 1" Patch Screws (81) to pull it
in the rest of the way.
Repeat this step for the other side of the
elliptical exerciser.
8
67
81
12
8
104
81
104
94
10