NordicTrack 360 - ATTACHING SQUAT BAR; ATTACHING HANDLES AND STRAPS; MOVING THE WEIGHT SYSTEM

18
65
69
ATTACHING THE HANDLES
A Handle (69) can be attached to an Eyehook (65),
or to a Housing Cable (not shown), with a Clip (61).
For some exercises, an Extension Strap (not
shown) should be attached between the Eyehook
or the Cable and the Handle with two Clips. Adjust
the Extension Strap to the correct length.
The Ankle Strap (not shown) can be attached in the
same manner.
61
61
71
70
55
ATTACHING THE SQUAT BAR
To use the Squat Bar (55), first remove the seat
(
see ADJUSTING THE SEAT on page 16). Then,
attach the pulley housings to the squat positions
(
see ATTACHING THE PULLEY HOUSINGS on
page 17). Next, attach the Squat Bar to the
Housing Cables (71) with four Clips (61) and the
two Extension Straps (70). Finally, adjust the
Extension Straps to the correct length.
61
76
Lever
MOVING THE WEIGHT SYSTEM
To move the weight system, step on the levers on
the Locking Casters (76) to unlock the wheels.
Move the weight system to the new location. Then,
relock the wheels on the Locking Casters.