5. The Console (87) requires four "D" batteries (not
included). Alkaline batteries are recommended. To
install batteries, turn the Console face down and
remove the Battery Cover (84), as shown in the inset
drawing. Insert four batteries into the Console. Make
sure that the negative ends of the batteries
(marked "--") are facing the springs in the
Console, Then, reattach the Battery Cover.
Connect the console wire harness to the Extension
Wire Harness (51).
Attach the Console (87) to the Upright (2) with the four
Console Screws (35) and the four Console Washers
(93) packaged with the Console. Be careful to avoid
pinching the wires.
Snap the bookrack onto the Console (87) in the indi-
cated location.
6. Remove the four M10 Nylon Locknuts (26) from the
welded bolts on the front of the Frame (1).
While a second person holdsthe Upright(2) near the
Frame (1), connect the Extension Wire Harness (51) to
the Wire Harness (85).
Align the four holes in the bracket at the bottom of the
Upright (2) with the welded bolts on the Frame (1).
Lower the Upright, feeding all slack Extension Wire
Harness (5t) and Wire Harness (85) into the
Upright, untilthe welded boltsare insertedintothe
bracket. Do not allow the Wire Harnesses to be
pinched.
Liftthe front of the Incline Frame (5). "Nghtenthe four
M1ONylon Locknuts(26) onto the welded boltson the
Frame (1).
7. Identifythe Left Pedal (41). Attach the Left Pedal to
the Left Spring Arm (3) with an M10 x 33mm Carriage
Bolt (61), an M1OWasher (63), and an Adjustment
Knob (77) as shown. Note: The Left Pedal can be
attached in any of five positions (see HOW TO
ADJUST THE PEDALS on page 9).
Attach the Right Pedal (not shown) inthe same way.
Make sure that both Pedals are in the same position.
5
87_
Wire
Harness
/
/
/
93 /
35 35
6
2
26
gl i
Welded Bolts
w
61 41
77
To Next Page
Loading...
