8. Apply a small amount of the included Teflon®lubricant
to a paper towel. Rub a thin film of the lubricant onto
the Chrome Tubes (21) on the Left and Right Spring
Arms (3, 4). Next, slide the Left Upper Body Arm (7),
which is marked with a sticker, onto the Chrome Tube
on the Left Spdng Arm. Slide the Right Upper Body
Arm (75) onto the Chrome Tube on the Right Spdng
Arm. Make sure that the Upper Body Arms are on
the correct sides--the upper ends should bend in
the direction shown by the arrows. Next, slide an
Axle Cover (74) onto the post on each Upper Body Arm.
Apply grease to theArm Axle (19). Insert the Arm Axle
into the rightAxle Cover (74) and the RightUpper Body
Arm (75). Next, insertthe Arm Axle intothe Upright(2)
untilthe leftend ofthe Arm Axle isflushwiththe left
side of the Upright.Then, insert the Arm Axle into the
leftAxle Cover (74) and the Left Upper Body Arm (7).
Center the Arm Axle (19). Using the included pedal
tool, tap two Push Nuts (15) about 118" onto each end
of the Arm Axle. Make sure that the Push Nuts are
turned as shown in the inset drawing. (Note: It may be
helpful if another person holds a block of wood against
one end of the Arm Axle while you tap Push Nuts onto
the other end.) Then, press an Axle Cap (34) ontoeach
end of the Arm Axle.
8
5
15
--2
21
9. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may
be left over after assembly is completed.
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
Ifyou purchasethe optionalchest pulse sensor(refer to
page 20), follow the steps belowto installthe receiver and
the shortjumper wire includedwith the chest pulse sensor.
Note:The includedlongjumper wire isnot needed.
1. Remove the four indicated screws from the back of the
Console (87). Liftoffthe front of the Console.
Screws
2. Peel the paper off the adhesive pad on the back of the
receiver(A). Odent the receiverexactly as shown,and
press it onto the Console (87) in the indicated location.
Connect the shortjumper wire (B) to the wire on the
receiver(A). Plugthe otherend of the short jumper wire
intoeitherof the indicated jacks on the Console (87).
Refer to step 1 above. Reattach the front of the
Console (87) with the four screws. Make sure that no
wires are pinched.
B
÷...!
Cylinder
8
To Next Page
Loading...
