5
Refer to the drawings below to identify small parts used in assembly. The number in parentheses by each draw-
i
ng is the key number of the part, from the PART LIST near the end of this manual. Note: Some small parts
may have been preattached. If a part is not in the hardware kit, check to see if it has been preattached.
PART IDENTIFICATION CHART
M6 Washer (61)
M12 x 75mm Screw (88)
M12 x 25mm
Patch Screw (91)
M10 x 65mm Carriage Bolt (121)
M6 x 170mm Screw (78)
M10 Washer (66)
M12 Washer (93)
M6 x 40mm Screw (80)
M10 x 175mm Bolt (83)
M10 x 107mm Bolt Set (106)
M6 x 20mm
Screw (100)
M4 x 19mm
Self-tapping Screw (39)
M6 x 65mm Screw (120)
M10 x 65mm Bolt (82)
M10 x 55mm Screw (94)
Arm Stop (36)
M10 x 168mm Bolt (46)
M10 Locknut (65)
To Next Page
Loading...
