NordicTrack ELITE 7.4 - Assembly - Part 6: Seat Components; Attaching Accessory Trays and Seat Handlebar; Connecting Wire and Attaching Seat

13
13
56
25
118
102
13. Identify the Right Accessory Tray (102).
Attach the Right Accessory Tray (102) to the
Seat Handlebar (25) with two M4 x 19mm Flange
Screws (118).
Repeat this step to attach the Left Accessory
Tray (56).
14
14. Tip: Avoid damaging the Control/Pulse Wire
(107) during this step.
Attach the Seat Handlebar (25) to the Seat
Frame (10) with four M8 x 40mm Bolts (105) and
four M8 Locknuts (106); start all the Locknuts,
and then tighten them.
See the inset drawing, which shows the left
side of the exercise bike. Plug the Control/
Pulse Wire (107) fully into the Frame Pulse
Receptacle (42) on the left side of the exercise
bike.
88
9
15
15. Attach the Seat (9) to the Seat Frame (10)
with four M6 x 38mm Screws (75) and four M6
Washers (88); start all the Screws, and then
tighten them. Note: Only two Screws and two
Washers are shown.
25
105
106
10
107
107
42
10
75