.
7
While a second person holds the Console (13)
near the Upright (4), connect the console wires
to the Extension Wire (59) and to the Pulse
Wire (61).
Insert the excess wire into the Upright (4) or into
the Console (13).
Tip: Avoid pinching the wires. Attach the
Console (13) to the Upright (4) with four M4 x
16mm Screws (43).
13
Avoid pinching
the wires
43
---_._ 43
.
Orient the Upright (4) assembly and the Pivot
Cover (12) as shown.
Slide the Pivot Cover (12) upward to the
Handlebar (5). Tip: Bend and flex the Pivot
Cover slightly to slide it over the Handlebar.
Attach the Pivot Cover (12) to the Handlebar (5)
with four M4 x 22mm Screws (31).
8
31
9
To Next Page
Loading...
Need help?
General
