What to do if my NordicTrack S25i Treadmill power turns off during use?
If your NordicTrack Treadmill's power turns off during use, ensure the power cord is securely plugged in. If it is, unplug it, wait five minutes, and plug it back in. Also, try removing and reinserting the key from the console. If the switch has tripped, wait for five minutes and then press the switch back in.
How to fix NordicTrack S25i when the power does not turn on?
If your NordicTrack Treadmill isn't powering on, ensure the power cord is correctly plugged into a surge suppressor, and the surge suppressor is plugged into a grounded outlet. If you're using an AFCI-equipped outlet and the circuit breaker trips, consider purchasing an arc filter. Also, check that the key is fully inserted into the console. If the power switch has tripped, wait five minutes before pressing it back in. Finally, the console may require activation; refer to assembly step 21 on page 17 to activate your console.
What to do if NordicTrack S25i Treadmill turns off during use?
If your NordicTrack Treadmill shuts off during use, try these steps: First, allow the power switch to reset by waiting five minutes, then press it back in. Ensure the power cord is securely plugged in; if it is, unplug it, wait five minutes, and plug it back in. Also, remove and reinsert the key from the console.
How to fix NordicTrack S25i walking belt slipping?
If your NordicTrack Treadmill's walking belt slips when you walk on it, first remove the key and unplug the power cord. Then, using the hex key, turn both idler roller screws clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each edge of the walking belt 2 to 3 inches off the walking platform. If the walking belt has shifted to the left, turn the left idler roller screw clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the left idler roller screw counterclockwise 1/2 of a turn. Then, plug in the power cord, insert the key, and walk on the treadmill for a few minutes. Repeat until the walking belt is centered.
Why does my NordicTrack Treadmill slow down when I walk on it?
If the walking belt on your NordicTrack Treadmill slows down when you walk on it, and you are using an extension cord, make sure it's a 3-conductor, 14-gauge (2 mm[2]) cord that is no longer than 5 ft. (1.5 m). If the walking belt is overtightened, treadmill performance may decrease and the walking belt may become damaged. Remove the key and unplug the power cord. Using the hex key, turn both idler roller screws counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform.
How to center a walking belt on NordicTrack Treadmill if it is off-center or slips?
If the walking belt on your NordicTrack Treadmill is off-center or slips, first remove the key and unplug the power cord. For an off-center belt, if it has shifted to the left, turn the left idler roller screw clockwise 1/2 turn; if it has shifted to the right, turn the left idler roller screw counterclockwise 1/2 turn. If the belt slips, turn both idler roller screws clockwise 1/4 of a turn. Ensure the belt is not overtightened—you should be able to lift each edge 2 to 3 inches. Plug in the power cord, insert the key, and walk on the treadmill to test; repeat adjustments as needed.
Why does the walking belt slow down when walked on NordicTrack S25i Treadmill?
If the walking belt on your NordicTrack Treadmill slows down when you walk on it: * Ensure you are using a surge suppressor that meets all specifications. * If the walking belt is overtightened, remove the key and unplug the power cord. Use the hex key to turn both idler roller screws counterclockwise 1/4 of a turn. The belt should be tight enough that you can lift each edge 2 to 3 inches off the platform. Keep the belt centered. Plug the power cord back in, insert the key, and test the treadmill.
Contact information for customer support in the United Kingdom.
Contact information for customer support in Australia.
Essential safety rules and precautions for treadmill operation.
Outlines requirements, tools needed, and initial preparation steps for assembly.
Guide to powering up the treadmill and operating it in manual mode.
Detailed steps for safely folding the treadmill into its storage position.
Procedures for cleaning and maintaining the treadmill for optimal performance.
Solutions for common issues with the treadmill's power and incline functions.
Guidance on correcting walking belt centering and slippage issues.
General| Cooling Fan | Yes |
|---|---|
| Speed | 0 to 12 mph |
| Display | 14" HD Touchscreen |
| User Capacity | 300 lbs |
| iFit Compatibility | Yes |
| Bluetooth | Yes |
| Folding | Yes |
To Next Page