7
2. With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (55) so that the treadmill is more stable;
do not fully fold the Frame yet.
Remove and discard the two indicated bolts (B)
and the shipping bracket (C).
Cut the shipping tie securing the Upright Wire
(87) to the Base (95). Locate a plastic tie in the
indicated hole in the Base, and use the tie to pull
the Upright Wire out of the hole.
Attach two Base Feet (90) to the Base (95) in the
locations shown with two #8 x 1" Tek Screws (5)
and two Base Foot Spacers (94).
Then, attach the other two Base Feet (90) with
two #8 x 1" Tek Screws (5).
2
95
5
55
90
90
5
5
5
90
94
90
87
Hole
94
1
. Make sure that the power cord is unplugged.
R
emove the 3/8" Nut (10), the 3/8" x 2" Bolt (8),
and the shipping bracket (A) from the Base (95).
Repeat this step on the other side of the
treadmill.
The 3/8" Nuts (10) and the 3/8" x 2" Bolts (8) will
be used in assembly steps 3 and 6. Discard the
shipping brackets.
95
A
8
10
C
B
1
To Next Page
Loading...
Need help?
General
