NordicTrack T9si - User Manual

Questions and Answers

T
Traci McclainJul 31, 2025
How to troubleshoot a NordicTrack Treadmill if the power does not turn on?
- L
  Lee WestJul 31, 2025
  If your NordicTrack Treadmill's power does not turn on: 1. Ensure the power cord is plugged into a properly earthed outlet. Use only a 3-conductor, 1 mm[2] (14-gauge) cord that is no longer than 1.5 m (5 ft.) if an extension cord is needed. 2. After plugging in the power cord, verify that the key is inserted into the console. 3. Check the reset/off circuit breaker on the treadmill frame near the power cord. If the switch protrudes, the circuit breaker has tripped. To reset it, wait five minutes, then press the switch back in.
M
Melissa MonroeAug 5, 2025
Why is the incline on my NordicTrack Treadmill not working correctly?
- C
  Calvin DavisAug 6, 2025
  If the incline of your NordicTrack Treadmill does not change correctly, put the key in the console and press one of the Incline buttons. While the incline is changing, take the key out. After a few seconds, put the key back in. The treadmill will automatically go to the highest incline and then back to the lowest. This will recalibrate the incline system.
A
Angela BakerAug 10, 2025
How to turn off demo mode on a NordicTrack T9si Treadmill?
- A
  Adam ClarkAug 10, 2025
  If the console displays on your NordicTrack Treadmill remain lit after removing the key, the console is in display demo mode, which is designed for store displays. To turn off demo mode, press and hold the Stop button for a few seconds. If the displays remain lit, see THE INFORMATION MODE on page 22 to turn off the demo mode.
H
howardhowardAug 15, 2025
How to fix a walking belt that is off-center or slips on a NordicTrack Treadmill?
- E
  Edward HobbsAug 16, 2025
  If the walking belt on your NordicTrack Treadmill is off-center, first remove the key and unplug the power cord. If the belt has shifted to the left, turn the left rear roller bolt clockwise 1/2 turn using the hex key. If it has shifted to the right, turn the bolt counterclockwise 1/2 turn. Avoid overtightening the belt. Plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until centered. If the belt slips, remove the key and unplug the power cord. Turn both rear roller bolts clockwise 1/4 turn. You should be able to lift each edge of the belt 2 to 3 inches off the platform when correctly tightened. Keep the belt centered. Plug in the power cord, insert the key, and carefully walk on the treadmill for a few minutes. Repeat until properly tightened.
A
Adrian WernerAug 20, 2025
What to do if the walking belt slows down when I walk on my NordicTrack Treadmill?
- M
  Michael WilliamsAug 20, 2025
  To address the issue of your NordicTrack Treadmill's walking belt slowing down when walked on: * Ensure that if you're using an extension cord, it's a 3-conductor, 1 mm[2] (14-gauge) cord no longer than 1.5 m (5 ft.). * If the walking belt is too tight, remove the key and unplug the power cord. Using the hex key, turn both rear roller bolts counterclockwise 1/4 of a turn. When properly tightened, you should be able to lift each edge of the walking belt 2 to 3 inches off the walking platform. Keep the walking belt centered. Plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the belt is properly tightened.
D
Dakota AllenAug 25, 2025
What to do if my NordicTrack T9si turns off during use?
- K
  kevin23Aug 26, 2025
  If the power turns off during use on your NordicTrack Treadmill: * Check the reset/off circuit breaker. If tripped, wait five minutes, then press the switch back in. * Ensure the power cord is plugged in. If it is, unplug it, wait five minutes, and then plug it back in. * Remove and reinsert the key into the console.