Nordson 3500V Series Customer Product Manual

A 3-48
lnstallation
Filling
the
Tank
with Adhesive
(contd.)
4103270
Fig.
A3-27 Filling
the Tank with
Adhesive
Flushing
the
System
WARNING:
Use a metal or
plastic
scoop
to
fillthe
tank with
adhesive. Never
use
your
bare hands.
3. See
Figure
A3-27.
Use a metal
or
plastic
scoop and fillthe
tank
with
adhesive
to within 25 mm
(1
in.) of the
top of the tank.
4.
Close the tank lid.
5. As the
system scans through
the system
settings, check that all
temperatures
are set as recommended
by
your
adhesive supplier,
6. Go to the next
procedure,
Flushing
the System
Before operating
your
unit for
the first time, flush
the system by
pumping
adhesive
through it to remove
trapped air
and
residue
left during factory
testing.
1.
Use one
of the
following
methods
to
prevent
accidental
gun
triggering:
.
Air-operated
guns:
turn off the operating
air.
o
Electric
guns:
turn off
the
gun
driver.
o
Hand-operated
guns:
lock the
trigger.
WARNING:
Hot! Flisk
of burns. Wear
heat-protective clothing,
safety
goggles,
and
heat-protective
gloves.
2.
Place
a
drain
pan
under each
gun
and remove all
gun
nozzles.
A3EN-04-[3V-X-4XXVj-1
3
41-3000v
lssued
5/00
@
2000 Nordson Corporation
All rights reserved

Nordson 3500V Series Specifications

General

Brand	Nordson
Model	3500V Series
Category	Melting Machines
Language	English