Nordson Asymtek
Mini and micro dispensing solutions for fluids and pastes
page 4 off 20
1.2 Safety instructions
Make sure, that you have taken care of the rules for accident prevention next to
reading this manual.
Do not disregard any caution sign; they give important notices to prevent accidents or
injuries. Caution signs are an important part of the safety rules for accident prevention
therefore need to be visible at l times.
Before commissioning, please do check all screws and see if they are well tightened.
Before starting to work with the pump, every worker needs to fully understand the
application and its demands. Do not let the pump run without any supervision.
Service and repairs may only be performed via trained personnel and the relevant
tools.
All needed accident prevention apparatus and fixtures must be installed before
operation. Make sure they are in good condition at all times.
Make sure that the pressure in the system has been neutralized while servicing the
pump. Switch off the power.
In case solvents are used, it may be needed to wear breathing protection masks.
Please ask your safety staff.
Never smell at openings after demounting the pump!
Take the needed precautions when working in an explosion proof zone!
Smoking is prohibited in the near of solvents and other inflammable products.
Only work on the pump and the pump drive shaft when the power is off.
Do not let the pump dry run.
Make sure that the suction side connection is vacuum proof and that the connection
of the pressure side is able to withstand the system pressure.
Do not use demineralised water.
To Next Page
Loading...
Need help?
General
