Introduction
2-8
Part 1073401_07
E 2021 Nordson Corporation
Optional Equipment
Optional equipment may be ordered to expand the functionality of DuraBlue
melters, including, but not limited to, the following:
S Communications cards that allow the melter to communicate with
other process equipment or a controller using standard network
protocols.
S Automatic pressure control that allows the melter to automatically
adjust adhesive output based on production requirements.
S Pressure gauge that provides a manifold hydraulic pressure
reading.
S Footswitch that allows manual pump activation.
S Air control kit that controls the module‐actuating air for a manual
manifold‐mounted applicator or a manual spray applicator.
S Hand‐held applicator hanger that provides a convenient and safe
method for storing a hand‐held applicator that is not in use.
S Pressure control valve knob that replaces the hex screw pressure
adjustment with a hand knob.
Refer to Section 7, Parts, for a complete list of optional equipment.
To Next Page
Loading...
