Noritz NRCB180DV - 13 Setting Temperature

66
13 Setting Temperature
How to Set Heating Temperature
The following Heating Temperature Setting can
be changed when the “Outdoor Reset Control” is
disabled (Refer to page 53-56).
3. Set the temperature using the / buttons.
* When you use Quick Connect Multi System,
temperature setting range is changed to below.
°F Mode: 100-140°F (In 5°F intervals)
°C Mode: 37 - 48°C (In 1°C intervals), 50°C, 55°C, 60°C
** Heating Temperature range depends on Installer Mode
Setting (I:05_HHt, I:06_HLt).
Temperature Setting Range
• To return to the home screen, press the BACK
button or let panel sit for approximately 20
seconds.
DHW*
°F Mode 90-140°F(In 5°F intervals) (11 Options)
°C Mode
32°C,35°C,37°C-48°C (In 1°C ntervals),
50°C,55°C,60°C (17 Options)
Heating
°F Mode
100-180°F (In 1°F intervals)
(81 Options)**
°C Mode
40-82°C (In 1°C intervals)
(43 Options)**
1. The ON/OFF button is ON.
(e.g.: 10:15AM)
2. Press the TEMP button once.
• The current “Heating Temperature Setting”
and “Heating Icon” will be blinking.
• Initial factory setting is 180°F (82°C in °C
mode).
3. Set the temperature using the / buttons.
(e.g.: 180°F)
How to Set DHW Temperature
• To return to the home screen, press the BACK
button or let panel sit for approximately 20
seconds.
1. The ON/OFF button is ON.
(e.g.: 10:15AM)
• When changing the temperature, make
sure to confirm with the customer that the
temperature of the Hot Water will be very high
and that there is a risk of scalding.
• Hot water temperatures over 125°F (52°C) can
cause severe burns instantly or death from
scalding.
• To ensure outlet temperatures do not exceed
120°F at faucets, a mixing valve must be
installed.
DANGER
2. Press the TEMP button twice.
• The current “DHW Temperature Setting” and
“DHW Icon” will be blinking.
• Initial factory setting is 110°F (40°C in °C
mode).
(e.g.: 110°F)
Setting Temperature