4
WARNING:
these instructions, all applicable local building codes
Refer to the furnace rating plate.
6).
page 7, page 8, page
9
, page 10.
12),
12)
, 12)12).
Connect this furnace to an approved vent system only,
as specified on page 10, page 11, page 12 page
13
.
a commercially available soap solution to check all
page 20.
Consult
29) and the rating plate for the
important that the duct system be designed to provide
improperly designed duct system can result in nuisance
shutdowns, and comfort or noise issues.
to areas outside the space containing the furnace, the
furnace casing and terminating in the conditioned space.
page 14.
page 6.
guidelines listed on
page 6.
compliance with regulation 248 CMR 4.00 and 5.00 for
installation of through – the – wall vented gas appliances
as follows:
the bottom of the vent terminal and the air intake is
installed below four feet above grade the following
be placed on each floor level where there are
recognized under 527 CMR.
compliance with the manufacturer’s instructions.
A copy of the installation instructions shall remain
of the installation.
directly above the location of vent terminal. The
bottom of the vent terminal and the air intake is installed
floor level where there are bedrooms. The detector
compliance with the manufacturer’s instructions.
A copy of the installation instructions shall remain
of the installation.
To Next Page
Loading...
