Nortek YAP1F - 2.3 Introduction of special functions; 3 Remote Controller YAD1 F

3DJH
User’s Manual of Remote Controller
within the valid receiving range.
（
14
）
Viewing ambient temperature
1
）
In unit on status, receiver light board or wired controller is defaulted to display
set temperature. Press TEMP button to view indoor or outdoor ambient
temperature.
2
）
When is displayed, it means the displayed temperature is indoor ambient
temperature.
3
）
When is displayed, it means the displayed temperature is outdoor ambient
temperature.
4
）
Ambient temperature displaying will be exited after 5s and then set
temperature will be displayed.
2.3 Introduction of special functions
（
1
）
Setting child lock
1
）
Press ▲ and ▼ button simultaneously to lock the buttons on remote
controller and
is displayed.
2
）
Press ▲ and ▼ button simultaneously again to unlock the buttons on remote
controller and
is not displayed.
3
）
If the buttons are locked, blinks 3 times when pressing the button and any
operation on the button is invalid.
（
2
）
Setting low-temperature dehumidifying
Under dry mode and when set temperature is 16°C, press ▼ button twice to enter
low-temperature dehumidifying function and set temperature is displayed as 12°C. If
low-temperature dehumidifying function has been set, press ▲ button to exit
low-temperature dehumidifying function and set temperature is displayed as 16°C.
Note: If energy-saving function is turned on, low-temperature dehumidifying function is
invalid.
（
3
）
Absence function
1
）
Press CLOCK and TEMP button simultaneously to enter absence function.
Temperature displaying zone displays 8.
2
）
Press CLOCK and TEMP button simultaneously again to exit absence
function. Temperature displaying zone resumes previous display.
3
）
In winter, absence function can keep the indoor ambient temperature above
0°C to avoid freezing.
Note: Absence function is only available in heating mode and it will be exited when
switchin
g
mode.