Nortek YAP1F - 2.1 Preparation before operation; 2.2 Introduction of operation function

3DJH
User’s Manual of Remote Controller
8 Set up&down swing status
9 X-FAN Set X-FAN function
10 TIMER ON Set timer on function
11 TIMER OFF Set timer off function
12 SAVE Set energy-saving function
13 SLEEP Set sleep function
14 LIGHT Set light function
15 CLOCK Set clock of the system
16 I FEEL Set I FEEL function
17 TEMP Switch temperature displaying type on the unit’s display
2.1 Preparation before operation
When using the remote controller for the first time or after replacing the batteries,
please set the time of the system according to current time in the following steps:
（
1
）
Pressing CLOCK button,
is blinking.
（
2
）
Pressing ▲ or ▼ button, the clock time will increase or decrease rapidly.
（
3
）
Press CLOCK button again to confirm the time and return to display current
time.
2.2 Introduction of operation function
（
1
）
Selecting operation mode
In unit on status, press MODE button to select operation mode in following
sequence:
 Floor heating, quick heating and heat supply modes are valid only with
specialized remote controller.

If chan
g
e to s
p
ecialized remote controller
,
p
ress MODE button and TEMP