Nortek YAP1F - 3.6 Replacing batteries in remote controller and notes

3DJH
User’s Manual of Remote Controller
1
）
In fan mode, set master mode indoor unit through ▲ and ▼ button:
2
）
Adjust set temperature to 30°C;
3
）
Within 5 seconds, press ▼ button and then press ▲ button repeatedly for
three times;
4
）
After finishing setting, “UC” is displayed on receiver light board for 5 seconds
and “MASTER” icon is displayed on wired controller.
（
4
）
Switching temperature scale
In unit off status, press MODE button and ▼ button simultaneously to switch
temperature scale between °C and °F.
3.6 Replacing batteries in remote controller and notes
（
1
）
Lift the cover along the direction of arrow (as shown in Fig 5①).
（
2
）
Take out the original batteries (as shown in Fig 5②).
（
3
）
Place two 7# (AAA 1.5V) dry batteries, and make sure the position of “+”
polar and “-” polar is correct (as shown in Fig 6③).
（
4
）
Reinstall the cover (as shown in Fig 6④).
Fig.5 Fig.6
Notes:
①
.
The remote controller should be placed 1m away from the TV set or stereo
sound sets.
②
.
The operation of remote controller should be performed within its receiving
range.
③
.
If you need to control the main unit, please point the remote controller at the
signal receiving window of the main unit to improve the receiving sensibility
of main unit.
④
.
When the remote controller is sending signal, “ ” icon will be blinking for
1 second. When the main unit receives valid remote control signal, it will give
out a sound.
⑤
.
If the remote controller does not operate normally, please take the batteries