Nortek YAP1F - Page 14

3DJH
User’s Manual of Remote Controller
button simultaneously, and then will blink for three times.
 If change to normal remote controller, press MODE button and TEMP button
simultaneously, and then
will blink for three times.
（
2
）
Setting temperature
In unit on status, press ▲ button to increase set temperature and press ▼ button
to decrease setting temperature.
Note: Under auto mode and when absence function is on, temperature adjustment
is invalid.
（
3
）
Adjusting fan speed
1
）
In unit on status, press FAN button to adjust fan speed in following sequence:
2
）
When is set, the whole unit operates in super high speed to achieve
quick cooling or heating.
Notes:
① Under auto, dry and fan modes or when quiet function is on, turbo function is
invalid;
② Under dry mode, fan speed is low and can not be adjusted.
（
4
）
Setting swing function
 Setting left&right swing
1
）
Under simple swing status, press button to adjust left&right swing
status;
2
）
Under fixed-angle swing status, press button to adjust left&right swing
angle circularly as below:
3
）
In unit off status, press ▲ button and button to switch between simple
swing mode and fixed-angle swing mode.
on the remote controller will be
blinking for 2 seconds during switching.
 Setting up&down swing
1
）
Under simple swing status, press button to adjust up&down swing
status
;