Nortel 8600 - Page 41

Configuring the system with the Setup Utility 41
Prompt Action
Please add system prompt
[ERS-8606]:
Press Enter to accept the default (ERS-8606), or enter a
different string of up to 20 characters.
Please select CPU Master slot
(5/6) [5]:
Press Enter to accept the default (5), or specify 6 for the master
CPU slot.
Master CPU mgmt port:
autonegotiation [n] (y/n)?
Enter n to accept the default, or enter y to indicate that you
want the master CPU management port to use autonegotiation.
speed (10/100) [10]: Press Enter to accept the default (10 Mbps), or specify 100
Mbps.
Do you want to enable automatic
savetostandby mode [n] (y/n)?
Enter y if you want the boot and runtime configuration files to
be saved on the backup CPU. Accept the default (n), if you
want the boot and runtime configuration files to be saved only
on the primary CPU.
Do you want to enable m-mode
support [n] (y/n)?
Enter y if you want the chassis to run in 128K M mode. Accept
the default (n), if you want it to run in 32K mode only.
To run in 128K mode, the CPU module must be an 8691 or
higher and the switch must have at least one 8600 module
(128K module).
If you enable m-mode support and you have a mixed
configuration of modules, the E-modules and legacy modules
are disabled.
Do you want to enable enhanced
operation mode support [n]
(y/n)?
Enter y if you want to enable enhanced operation mode.
Accept the default (n), if you do not want to enable enhanced
operation mode. If you enable enhanced operation mode
and you have a mixed configuration of modules, the legacy
modules (E- or M-modules) are disabled.
Do you want to enable CPU
High Availability mode [n] (y/n)?
Specify y if you want to enable CPU high availability (HA)
mode. Accept the default (n), if you do not want to enable CPU
HA mode.
Do you want to enable
vlan-optimization-mode support
[n] (y/n) ?
Specify y if you want to enable vlan-optimization-mode
support. Accept the default (n) if you do not want to enable
vlan-optimization-mode support.
Do you want to enable r-mode
support [n] (y/n) ?
Specify y if you want to enable r-mode support. Accept the
default (n) if you do not want to enable r-mode support.
Do you want to enable FTP [n]
(y/n)?
Enter y if you want to enable FTP for remote users. Accept the
default (n), if you do not want to enable FTP.
Do you want to enable RLOGIN
[n] (y/n)?
Enter y if you want to enable Rlogin for remote users. Accept
the default (n), if you do not want to enable Rlogin.
Do you want to enable TELNET
[n] (y/n)?
Enter y if you want to enable Telnet. Accept the default (n), if
you do not want to enable Telnet.
Do you want to enable TFTP [n]
(y/n)?
Enter y if you want to enable TFTP. Accept the default (n), if
you do not want to enable TFTP.
Nortel Ethernet Routing Switch 8600
Quick Start
NN46205-310 01.01 Standard
4.1 21 December 2006
Copyright © 2006 , Nortel Networks Nortel Networks Confidential
.