Appendices
89
Component Specification Assembly Position Qty.
80×3.55G Back Support 2
85×3.55G
Bearing Block of the Mater
Pinion Shaft
2
170×3.55G Drive Shaft Cover 2
175×3.55G
Inner End of the Half Axle
Sleeve
2
ATTENTION: Before using farm implements, operators should carefully read the “Use and Maintenance
Instructions” and understand the structure, performance, operation, and supporting features to avoid damaging the
implements and/or personal injury.
NOTES:
1. Before purchasing farm machines and implements, select a good match with your machine or
consult a reputable dealer. Understand your operational conditions (soil resistance, agricultural
requirements, etc.) of the areas where you will be working and referring to this list.
2. Determine the main technical parameters of the farm machines and implements such as models
according to the operational conditions (soil resistance, agricultural requirements, etc.) of the areas
where you will working and refer to the advisories in order to get the appropriate match. Improper
matching will make the new machinery ineffective and, possibly, dangerous.
3. Working efficiency can depend on the implement, the performance of which may vary with
operational conditions (soil resistance, agricultural requirements, etc.). Therefore, you should
determine working speed and width, etc. and make your purchase accordingly.
Distributed by Northern Tool & Equipment Co., Inc.
Burnsville, MN 55306-6936
Made in China
To Next Page
Loading...
