3
IMPORTANT SAFETY INFORMATION
USING EQUIPMENT SAFELY
Your set-top box has been manufactured to meet
international safety standards, but you must take care
to operate it safely.
It is important that you read these safety instructions.
WARNING: Remember that contact with AC
mains can be lethal or can cause severe electric
shock. To avoid the risk of electric shock:
Never remove the top cover from the 12 V
power supply unit, as there are high-voltage live
parts inside. There are no user-serviceable parts
inside this power supply unit.
Never remove the top cover from your set-to
p box
.
There are no user-serviceable parts inside it.
On the rear panel of your set-top box, there is a
tamper-evident label that states ‘Warranty void
if broken or removed’.
Make sure all electrical connections are properly
made.
Do not connect any equipment to the mains supply
until you have properly connected all the other leads.
Before you disconnect any other equipment
from your set-top box’s rear panel, put your
set-top box into standby, then disconnect
your set-top box from the power supply (by
disconnecting the 12 V power supply unit from
the mains socket on the wall).
Never push anything into holes, slots or other
openings in the case (except a smartcard into
the slot provided).
The model number, serial number and electrical
rating of your set-top box are on a label on its base.
CAUTION:
Do not use or store your set-top box in hot,
cold, damp or dusty places.
Do not block the ventilation holes of your set-
top box. Leave a gap of at least 10 cm above
and around it to allow for adequate ventilation.
Never stand it on soft furnishings.
Do not put anything on your set-top box which
might drip or spill into it. Never stand objects
lled with liquids, such as vases, on top of your set-
top box.
Do not place your set-top box in an
unventilated cabinet or on top of a unit that
emits heat (e.g. a VCR).
Never place naked ame sources, such as lighted
candles, on or adjacent to your set-to
p box
.
CONNECTING TO THE MAINS SUPPLY
• Your set-top box is designed for use only with the
supplied 12 V power supply unit.
• The 12 V power supply unit operates with a 220-
240 V AC, 50 Hz mains supply. Do not connect it
to any other electricity supply than this.
• Connect the 12 V power supply unit to your set-
top box. Then insert the 2-way connector on the
supplied mains lead into the 12 V power supply
unit, then nally insert the mains plug into the
mains supply at the wall socket.
• To disconnect power from your set-top box,
always remove the 12 V power supply unit from
the mains supply (rather than disconnect the
12 V power supply unit from your set-top box).
Therefore you must install your set-top box near
to the mains socket-outlet, which should be
easily accessible.
• If you are in any doubt about the mains lead,
its plug or its connection, consult a competent
electrician.
To Next Page
Loading...
