14
AUDIO OUTPUT
You can access the Audio Output settings by navigating through the following screens:
Menu > Settings > Advanced Options > Television Setup > Audio Output
Item Settings Comments
Analogue Out Mono Audio output is single channel.
Stereo* Audio output is two channels.
5.1 Out Passthrough The Dolby Digital audio is routed from the DIGITAL AUDIO OUT connector.
Downmix* The Dolby Digital audio is converted to analogue stereo.
Volume
control
Fixed Audio output cannot be changed using the remote control unit.
Variable* Audio output can be changed using the remote control unit.
Lip-sync Delay 0* to 300 ms If you have an HD TV, and you connect a separate audio system to the
coaxial digital audio lead you may have to adjust the Lip-sync Delay
setting.
This is because the length of time your HD TV takes to display the video
information may be slightly greater than the time taken for the audio
signal to reach the loudspeakers. In this case, you would hear someone
speaking just before his/her lips moved. To correct this situation, a delay
must be added to the audio signal, until it is “in sync” with the on-screen
video.
5.1 Selection Automatic Dolby Digital audio is automatically played if it is available on a channel.
Manual* Dolby Digital audio is not automatically played even if it is available on a
channel. You will need to turn it on by pressing the blue button.
* Default setting
To Next Page
Loading...
