17
EN
4 / PROGRAMMING YOUR APPLIANCE
• PROGRAMMING A WASH CYCLE (continued)
... as well as the estimated time
remaining until the end of the cycle.
•Operations to perform (continued)
Display
— Turn the program selector to the “0” position
NB : Cancellation means you always have to re-program
from scratch.
If you have cancelled during washing, if you need to drain
the water, run a “Spin” program and set a suitable speed.
AA
All displays are extinguished
•Cancellation during programming, washing or
during pause
NB : After the spin, your washing machine automatically
cools the laundry and positions the drum with the opening
at the top for easier access to the laundry. This operation
lasts 3 minutes maximum.
The display then shows “- 0 -”, which tells you the cycle
has finished.
— Turn the program selector to the “0” position You can
then open the lid and remove your laundry.
AA
33
•Indication of End of cycle
— Choose immediate start by pressing the “Start/Pause”
button ...
The cycle sequence indicator lights up.
The program begins.
11
EE
Display
Display
Throughout the cycle, the machine
indicates the current phase of the
cycle...
Dauer/min
Zeitvorwahl
Zeitvorwahl
(the indicator light flashes on and
off)
... You can delay the start time by between 1 and 24 hours.
— To do this, press the “Delayed start” button (refer to
the chapter on "OTHER FUNCTIONS" – “Delayed start”).
The display then shows the time before the cycle
starts. (When under one hour, the time is displayed in minu-
tes).
33
DD
Important :
Before switching your machine on, check that the electrical power cord is connected and
the water valve is open. Ensure that the drum doors and the machine lid are properly closed.
In the "End of cycle" phase, when ”StOP” is displayed, any action on one of the control elements
(selector or buttons) lets you return to "Programming" mode.
For safety reasons, at the end of a cycle, we recommend disconnecting the power cord and shut-
ting off the water supply valve.
To Next Page
Loading...