27
EN
5 /
EVERYDAY MAINTENANCE OF YOUR APPLIANCE
•Upkeep of internal parts
To ensure better hygiene we recommend the
following:
— leave the lid open for a while after washing.
— clean the plastic and rubber parts around
the cavity access around once a month using
a product with low bleach content. Rinse to
eliminate all residue from this product.
— run a 90°C wash cycle at least once a month
•Periodic checks
We recommend that you check the condition
of water supply and emptying hoses. If you
observe the slightest cracking, do not hesi-
tate to replace them with identical hoses avai-
lable from the manufacturer or its After-Sales
Service.
•Replacement of the water supply
hose
When changing it, ensure it is well tightened
and that there is a seal at both ends.
•Replacement of the power cord
Important :
To ensure your safety, this must be car-
ried out by the manufacturer's after-sales
service team or a qualified professional.
•Risk of freezing
If there is a risk of freezing, disconnect the
water supply hose and empty the water that
may be left in the emptying hose, placing the
hose as low as possible in a cup.
• AUTOMATIC SAFETY FEATURES
•Anti-foam safety
Your washing machine can detect excessive
production of foam during the spin.
In this case, the spin stops and the machine is
emptied.
The cycle then resumes, adjusting the spin
speeds and possibly adding an extra rinse.
•Water safety
During operation, the water level is constantly
checked to prevent any overflow.
•Spin safety
Your washing machine has a safety feature
that can limit spinning if it detects that the
load is poorly distributed.
In this case, your laundry may be insufficiently
spun. Spread out your laundry evenly in the
drum and program a new spin.
•Lid opening safety
— As soon as the wash cycle has begun, your
machine lid locks.
— As soon as the cycle ends or when the
machine is at full tank stop, the lid unlocks.
— If you have programmed a "Delayed start",
the lid is not locked during the wait period pre-
ceding the start of the cycle.
— If you want to open the lid during the cycle,
press briefly on the “Start/Pause” button
and wait at least 1 to 2 minutes so that the lid
safety feature unlocks.
Important :
Depending on the moment during the
cycle when you wish to open the lid, this
period may be longer since a cooling period
is required.
Indeed, during the cycle, to prevent the lid
from unlocking, the temperature inside the
machine must not exceed a certain thres-
hold, to prevent serious burns.
FF
To Next Page
Loading...