Novamatic WT 1364 E - Appliance Installation; Removing Transport Braces

7
EN
• REMOVING THE TRANSPORT BRACES
Important :
Before use, the following operations
must be performed.
These operations involve removing all parts
used to immobilise the tank of your appliance
during transport.
These "brace removal" operations are
necessary for the smooth operation of your
appliance and compliance with current
safety standards.
If these operations are not performed in full,
this may cause serious damage to your
appliance during operation.
Retirez préalablement la cale en polystyrène
expansé située sous le couvercle.
••
Front transport brace :
— Open by pressing on the bosses on each
side of the baseboard at the same time
while pulling the baseboard towards you
(Fig.
04).
— Using a 10 mm wrench, unscrew the "front"
brace maintenance screw made from red
plastic
(Fig. 05).
— Remove the "front" brace (Fig. 06).
— Plug the hole left by the brace using the
cover provided
(Fig. 07).
— Reattach the baseboard (Fig. 07).
CC
BB
AA
2 / INSTALLING YOUR APPLIANCE
Fig. 04
Fig. 05
BB
AA
Fig. 06
BB
Fig. 07
CC