8
EN
2 / INSTALLING YOUR APPLIANCE
• REMOVING THE TRANSPORT BRACES (continued)
DD
EE
EE
FF
GG
Fig. 08
Fig. 09
HH
••
Rear transport brace :
— Remove the 2 screws and the 4 screws
DD
the 4 screws back in their original posi-
tion in the body.
Tip :
We recommend that you keep all parts
for bracing as you will have to replace them
if you need to move your machine at a later
date.
All these parts, as well as those used for the
entire machine are made from recyclable
materials. Please consider this when dispo-
sing of them at the end of your machine's
service life.
Information :
Before leaving the plant your
appliance was thoroughly tested; therefore
you may notice a small amount of water in
the tank or in the detergent dispensers.
Information :
If you wish to place your appliance in
line with your furniture units, you can break
the hose attachment hooks.
Important :
Be careful not to crush the hoses.
EE
using a 10 mm tube wrench or a flat head
screwdriver
(Fig. 08).
— Remove the brace
.
— Release the power cord from the plastic
part attaching the transport brace.
— Plug the holes left by the brace using the
remaining 2 covers
(Fig. 09)
and screw
HH
GG
FF
EE
To Next Page
Loading...