24
EN
•Remaining Time Display
— During programming, the display tells
you the estimated duration of the program for
a standard load (*).
(*) The time indicated by the machine at the
start of the program may vary during the
cycle:
— After estimating the load contained in the
drum.
— If you change the washing temperature
(even during the spin), if you add or remove
options, the time will be recalculated and
updated on the display.
33
— During the cycle, the display shows
you the estimated time remaining until the end
of the cycle at all times.
— If power is disconnected during the wash
phase, when power returns the time displayed
may be less than the actual remaining time.
This time will be adjusted at the start of the
rinse phase.
33
4 / PROGRAMMING YOUR APPLIANCE
• OTHER FUNCTIONS (continued)
•Delayed start
You can delay the start of your program by 1 to 24 hours to take advantage of preferred energy
rates or to end the cycle at the time desired.
To do this, select the required duration by pressing successively on the "Delayed Start" but-
tons until you reach the duration required.
NB: After a few seconds, the digit on the display will flash on and off. The display will count
33
DD
- Wash :
Cotton - 60°C - 6 kg - No option - Max spin
- Dry :
Cotton - High drying - 4 kg
- Properties :
230V - 50Hz - 10A - 2200W.
For the results indicated on the energy label, the tests are conducted in accor-
dance with European Directive 96/60/CE.
• PROGRAM FOR COMPARATIVE AND STANDARDISED TESTS
down the time remaining before the cycle will start (the final hour is counted in minutes ).
•Automatic cooldown
If you select the “Colours” option and a “Washing and subsequend drying” cycle your laundry is
cooled for 2 hours at the end of the drying cycle. This prevents formation of wrinkles, which are par-
ticularly visible on dark-coloured laundry.
The “Drying” light remains on during the entire cooldown period.
To access your laundry during this period, cancel the automatic cooldown by pressing the
“Start/Pause” button. Then turn the program selector back to “0”.
EE
To Next Page
Loading...