19
13 Prepare Your Head for Transducer Array Placement
Wash your head with a gentle shampoo.
If this is the first time you have used the transducer arrays, ignore this step and skip ahead to the next step (shaving).
If you are replacing transducer arrays, you, or your doctor or caregiver if needed, should wipe the skin with baby oil
to remove any old adhesive from other transducer arrays. Baby oil is used to remove old adhesive. It will not stop
the device from working.
Shave your entire scalp using an electric shaver. Do not leave any stubble.
Wipe your scalp with 70% alcohol (available at your local pharmacy without a prescription).
Use a high potency steroid cream if your scalp is red (your doctor will prescribe this for you). Treat open sores on
your scalp following your doctor’s instructions. If you use a cream or ointment, apply it to the scalp, wait at least
15 minutes and wipe your scalp again with 70% alcohol. Apply the transducer arrays after your scalp is dry.
Prepare Your Head for Transducer Array Placement\\DC - 099263/000001 - 12620961 v1
To Next Page
Loading...
