23
17 Connecting & Disconnecting the Portable Battery
Option Two: If you are not near the wall power supply, or if the battery has totally depleted please replace the battery
using these steps:
1. Press the TTFields button to stop the treatment.
2. Turn o the device using the power switch (on the bottom of the device).
3. Remove the battery from the battery slot by pressing the blue buttons on the side of the battery
and lifting the battery cartridge out of the slot.
4. Select a fully charged battery from the charger.
5. Slide the fully charged battery in the battery slot, gently push down to lock the battery in place.
6. See the next section to check the battery gauge.
7. Turn ON the device using the power switch and wait for the system to run a self-check (this takes
about 10 seconds). To start treatment press the TTFields button (see Section 22).
8. Insert the used battery into the charger for recharging (see Section 18).
Connecting & Disconnecting the Portable Battery
To Next Page
Loading...
