MAINTENANCE AND INSPECTION
DAILY MAINTENANCE
• C6CSD, C8CSD and C10CSD Sheet Pile Drivers use oil lubrication for the
bearings, which may require semi-annual maintenance.
• Periodically check all fasteners and tighten as necessary. The hydraulic motor
bolts require thread adhesive.
• Periodically check the rubber mounts for deterioration or cracking. Wash oil or
grease from the rubber surface.
• Oil leakage out of the eccentric housing (sp2) or lower frame vent (EN) is an
indication of hydraulic motor shaft seal failure.
• Inspect eccentric (roller) bearings if they become noisy. Noisy bearings could be
an indication of insufficient lubrication.
• Do not operate the Sheet Pile Driver if the carrier hydraulic reservoir temperature
exceeds 180°F (80°C).
To Next Page
Loading...