- Page 26 -
Nu-Tek Levator Elite User Manual
Data Report for progress
The Nu-Tek Levator Elite has a built-in ability to store and send Patient’s day
-by-day home compliance and periodic assessment data to the PC. (The
Nu-Tek Software can be purchased at an additional cost, for details contact
Shenzhen Dongdixin Technology Co., Ltd.
Step by step with the Data Report
Step 1. Check or Set the Date/Time
View the next page on how to change Date and Time settings. The
statistics will be saved on a daily or periodic basis. It is very important
to make sure the date is correct.
Step 2. Select the program to train or assess
After completing the training session or assessment, the record is
stored automatically. The device can store every 90 records of 90 days
or 90 weeks.
Note: Only in Patient Mode, the training record can be stored automatically.
Step 3. Instruct the patient when, how often and how to use the device.
The patient follows the clinician’s instructions on how to use the
program, and how to handle statistics recorded for training or
assessment.
Step 4.Connect the Device to the PC and download the statistics to PC.
After long term training (days or months) and periodic assessment
(after weeks or months) is completed, connect the device to the PC
via the USB cable, switch on device and select COMMUNICATE. Then
press ESC button to main menu. Select DATA MANAGE, press the
OK button to select Send data to PC, then press the OK button to
download the statistics to the PC.
Step 5. PATIENT statistics
The device stores and records one patient’s training and assessment
data at a time for up to 90 recordings. This data can be downloaded
onto the Nu-Tek PC software. To record new patient’s data the Device
must rst clear the saved data.
To Next Page
Loading...
Need help?
General
