- Page 32 -
Nu-Tek Levator Elite User Manual
Electrodes Types and Tips
※ Self-Adhesive Hypoallergenic electrodes have a typical life span (if looked
after) of 4/6 weeks. We recommend cleaning the skin before placing the
electrodes. After use place the electrodes back onto the plastic lm and
in the zip-tag plastic pouch. Store in a cool environment.
Skin Electrode Types Available: 50 x 50mm, square (recommended for
general use) other electrode sizes are available, typically 50 x 100mm,
40 x 40mm and 30mm dia.
A Few Good Tips [Self- Adhesive Electrodes]
※ If you nd the electrodes will not stick due to oily skin, cleanse the skin
with soap and water, then rinse and dry the area around the electrode site.
If this does not work, try cleansing the skin with a swab impregnated with
alcohol.
※ Clip away hair on the skin using scissors; don’t use a razor to remove the
hairs!
※ The electrodes conductive material is water-based. If it becomes saturated
(e.g. from perspiration), it will lose its adhesive qualities. After use leave
the electrodes face up overnight to dry out (replace on plastic lm in the
morning). At some point the electrodes will become dry. Moisten the
adhesive surface with a few drops of water, and apply onto the plastic lm
overnight. This procedure will increase the electrode life by few more days.
※ Place the tacky surface to the prescribed skin area by pressing the
electrode rmly against the skin.
Transparent Film
Connection Cables
To Next Page
Loading...
Need help?
General
