- Page 9 -
Nu-Tek Levator Elite User Manual
Quick Start Instructions
1. Insert four AA batteries
Remove battery cover. Insert batteries as labelled inside the battery
compartment and then replace the back cover.
2. Insert lead wire
Insert the lead wire/s into the sockets of the device. The round black EMG
reference lead wire connects to the round black socket in the top of the
unit; the red stimulation lead wire connects to the red socket.
IMPORTANT! If you don’t use the round EMG reference wire (REF), your
EMG and ETS results will be inaccurate.
3. Skin electrodes/probe placement
When using the EMG or ETS phase, connect the EMG reference lead wire
to a surface skin electrode and place it appropriately on the body, making
sure the skin is free from grease and dirt; repeat the above procedure with
the other two skin electrodes. If using a probe, place the single surface
skin electrode on the thigh area and then insert the probe.
4. Turn on Levator Elite by pressing the ON/OFF button once for 3 seconds.
Note: This product has a Patient Mode which we suggest the general
public use and a Therapy Mode which is more practical for the Clinician.
Selecting the Therapy Mode requires a password. When selected the
Patient Mode, the product would be locked. The details setting method
refer to “Change using mode” of page 27. In Patient Mode, you can not
select the therapy program and set the parameters of the custom
program.
5. The EMG, the Patient Mode uses the Nu Tek bar graph; the Therapy Mode
uses a line graph.
6. There are pre-set (ready to use) programs and custom programs (which
can be adjusted by the patient or therapist in Therapy Mode). The
parameters of pre-set programs can not be changed.
Note: Individual custom programs set for the patient should ideally be
under the guidance of a doctor or therapist in Therapy Mode.
Using the circular button black arrow keys navigate to select EMG and press
the OK button. The screen displays Training Program and Assessment
Program. In Assessment Program, there is only one preset program: Threshold
= 30μV, WIDE Filter, ABOVE Biofeedback sound, Work time = 5s, Rest time =
5s, and 5 Trials, AUTO threshold is advised to be used to see the treatment
progress during periodic training. In the Training program, there are two
custom programs, you can select all the EMG Biofeedback parameters by
using the up and down black arrow keys, and change settings by using the
THRS+ and THRS- buttons. In Patient Mode, the program, work time, rest
time,trial and A/M threshold can not be adjust.
To Next Page
Loading...
Need help?
General
