- Page 10 -
Nu-Tek Levator Elite User Manual
When you have completed your settings, press the OK button which will take
you into the vertical Bar graph Patient Mode or the EMG line graph Therapy
Mode, then press the OK button to begin the session.
Working with EMG
※ Always use the Reference wire (REF) for more accurate EMG measurement!
Place the reference electrode anywhere on your skin. When using the
device with a vaginal probe, place the reference electrode on your thigh.
※ Place the device on the desk, in its stand or hold the device.
※ Relax so that the microvolt reading is as low as you can manage; below
6µV is acceptable while below 4µV is ideal.
ETS (EMG TRIGGERED STIMULATION) Patient / Therapy MODE
Using the circular button select ETS, press the OK button to enter the ETS
parameter settings interface. Using the circular button scroll and using the
THRS+ and THRS- buttons to change the EMG Biofeedback and Stimulation
settings. In Patient Mode, the program, work time, rest time,trial, A/M
threshold and stimulation parameters can not be adjust. When you have
completed your settings, press the OK button this will then take you into the
standby mode. Press the mA+ button to increase the electrical current ( mA)
and to start the treatment. As soon as the patient reaches the target level
(threshold) in the work period stimulation takes place for several seconds
which helps to contract the pelvic muscles. Ideally contract your pelvic
muscle along with the electrical stimulation.
STIM (STIMULATION) MODE
Using the circular button select STIM, press the OK button which brings up
the pre-set and custom programs, in Therapy Mode press the THRS+ or
THRS- buttons to select the required program. Press the OK button, and then
press the mA+ button to increase the electrical current (mA) and to start the
treatment. The parameters of pre-set programs can not be changed; those of
custom programs can be adjusted by the therapist in Therapy Mode. Using
the THRS+ and THRS- the phase parameters of the program can be viewed.
At the end of the session the screen will display the Date and Time, Average
Current used (mA), Program, and the Frequency (Hz) used. Only the mA
(current) will be saved.
COMMUNICATE
Connect the device to the PC via a USB cable, then using the circular black
arrow keys select COMMUNICATE, press the OK button, the data can be
transferred between PC and the device. (This function is an optional extra
To Next Page
Loading...
Need help?
General
