N4
Before Product Installation
Production Installation and Use
Move the product after separating the power supply
from connecting lines if the product is moved.
(Otherwise, it might cause electric shock, injury
and/or damage to the product.)
Connect the power supply after connecting the
controller first.
(Otherwise, it might cause damage to the product.)
Install the product at a flat floor.
(Otherwise, it might damage the product.)
Do not drop or shock the product.
(Otherwise, it might damage the product.)
Check out the applied voltage before any use.
(Otherwise, it is likely that the electrical shock or
fire occurs.)
Do not place any inflammable substance on the
product, such as candle light or cigarette light.
(Otherwise, it is likely to cause the electrical
shock or fire.)
Avoid using the product in a closed place
with any fuel and/or chemical.
(Otherwise, it might cause injuries or fire.)
Do not install the product in a place with the
frequent access.
(Otherwise, the product might be damaged.)
Do not install the product in a place with
much moisture or water.
(Otherwise, the product might be damaged.)
Be careful not to expose the product to the
direct sunlight.
(Otherwise, the product might be damaged.)
To Next Page
Loading...
