8
Trigger
Machine Handle Operation
To start the machine pull one or both triggers in and press the start button with the deck down, this will start the brushes spinning
and the battery power indicator will illuminate to show the power level.
With either trigger pulled in press the water on button, this lights
up blue to indicate it is on.
Press the vacuum on button, this lights up blue to indicate it is on
and the vacuum starts. You are now ready to start cleaning.
Trigger Start button
Water On / O Vacuum On / O
To lower the oor-tool, press down on the left foot pedal lever at the rear of the machine (8-A).
To lower the machine deck to the ground. Stand behind the machine, grip the handles.
With your right foot push the right pedal forward (9-B). (By pushing lever the front support
wheel retracts under the deck (9-C)).
Pull the small lever on the right hand side of the handle upwards (10-D) and then pull the
handle backwards.
To raise the oor-tool (for over-scrubbing without picking up water) use the toecap
locations to the rear of the oor-tool (E or F).
Quick Set-up Guide
To Next Page
Loading...
Need help?
General