Numatic TTB 6055 - Machine Setup

22
Featuring the Nulock brush system.
The brush is simply pushed and twisted to lock, making tting and removal a simple process.
Slide the brush / pad under the brush deck (Fig.5).
Fit the brush / pad onto the Nulock drive chuck, twist to lock the brush / pad in place (Fig.6).
Safety gloves are recommended for the changing of used brushes.
550mm Brush or a 500mm Pad on the TTB 6055.
Machine Set-Up
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
! !
Fitting the Brushes
Fitting the Floor-tool
The oor-tool has been designed for quick tting, allowing easy squeegee blade replacement and a safety knock-off
feature if the oor-tool gets snagged, whilst in transit.
Push waste collection pipe onto the
oor-tool; ensure a tight t (Fig.8).
Raise the oor-tool for transit or lower
for cleaning operation using the lifting
handle tted to the back of the machine
(Fig.9).
Note:
It is easier to t the oor-tool if the weight of the machine is resting on the brush. Ensure the brush is tted rst.
Fit the oor-tool and retain using the detent pin (Fig.7).
9
6
5
7
8