Numatic TTB 6055 - Page 24

24
Machine Set-Up
Ret vacuum hose to the
Floor-tool when nished.
The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum is switched
off. If you need to remove the U-bend clip for any reason always ensure it is retted correctly before you resume operation.
Fitting the Hose Guide
Filling the Clean-water Tank
The TTB 6055 is equipped with a large capacity clean-water tank allowing, for large areas to be covered in a single ll.
To ll the clean-water tank, extend the hose located to the rear of the machine in the centre of the removable ller cap, see
(Fig.10). Pull out hose, (Fig.11). Open the stopper (Fig.12) and place hose under water tap, or use a hose to commence
lling, (Fig.13). Or the tank can be lled by unscrewing the ller cap and using a bucket or similar container (Fig.14).
10
11
12
13
14
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the lling process. If using a bucket or similar, ensure it is always clean and free from debris.
250mm - 300mm
Note:
DO NOT push the vacuum hose onto the Floor-tool with the Floor-tool in the raised position.