14
Lowering the brush deck
Lowering the oor tool
Fig.26
Fig.28
After preparing the oor (see previous section), we are now ready to set the controls to suit the cleaning conditions.
Before any settings can be applied, ensure the brush deck is lowered (Fig 29).
Move the Floor tool lever, to it’s lower position (Fig 27).
Note: The machine will still reverse with the Floor tool in the lowered position, this could possibly damage the
blades. Raise the oor tool (Fig 26) before selecting reverse.
The control for lowering the brush deck can be found to the rear right of the machine (Fig 28).
Lower the brush deck by releasing the left foot pedal to the upper position (Fig 29).
Note: If the brush width has not been set, see ‘Setting the width adjustment’ on page 10 before proceeding.
Fig.29
Fig.27
Machine Operation
To Next Page
Loading...
Need help?
General