84 26.11.07 1 689 979 924N
15.2 Error weighing system
Error code 10 30 *
No signal weighing system left-hand side
Cause:
- Weighing system has been activated in the configuration
menu, but does not exist physically.
- Wire breakage of the sensor line
- Weighing system defective (unlikely, since weighing system
on the left-hand side consists of 4 sensors = composite
signal)
Error code 10 31 *
When switching on, no cal-check-function of the weighing sys-
tem on the left-hand side.
Cause:
- Sensor line defective.
- Cal-check-line interrupted (wire breakage)
Error code 10 32 *
Weighing system left-hand side has not been calibrated.
Error code 10 35 *
When switching on, zero point weighing system left-hand side
EEPROM compares to current weight. If the difference is too
high, the error is displayed.
Cause:
- Weighing system not calibrated
- Vehicle is on or in left-hand roller set
Error code 10 40 *
No signal weighing sensor right-hand side
Cause:
- Weighing system has been activated in the configuration
menu, but does not exist physically.
- Wire breakage of the sensor line
- Weighing system right-hand side defective (unlikely, since
weighing system on the right-hand side consists of 4 sensors
= composite signal)
Error code 10 41 *
When switching on, no cal-check-function of the weighing sys-
tem on the right-hand side.
Cause:
- Sensor line defective.
- Cal-check-line interrupted (wire breakage)
Error code 10 42 *
Weighing system right-hand side has not been calibrated.
Error code 10 45 *
When switching on, zero point weighing system right-hand side
EEPROM compares to current weight. If the difference is too
high, the error is displayed.
Cause:
- Weighing system not calibrated
- Vehicle is on or in right-hand roller set
15.3 Error inductive sensor
Error code 11 00 *
No signal touch rollers speed left-hand side
Cause:
- Roller set has been activated in the configuration menu, but
does not exist physically.
- Inductive sensor defective
- Sensor line defective
- Distance between inductive sensor and feeler roller > 3 mm
Error code 11 05
No signal touch rollers limit switch left-hand side
Cause:
- Roller set has been activated in the configuration menu, but
does not exist physically.
- Inductive sensor defective
- Sensor line defective
- Distance between inductive sensor and switching lug > 3
mm
Error code 11 10 *
No signal touch rollers speed right-hand side
Cause:
- Roller set has been activated in the configuration menu, but
does not exist physically.
- Inductive sensor defective
- Sensor line defective
- Distance between inductive sensor and feeler roller > 3 mm
Error code 11 15
No signal touch rollers limit switch right-hand side
Cause:
- Roller set has been activated in the configuration menu, but
does not exist physically.
- Inductive sensor defective
- Sensor line defective
- Distance between inductive sensor and switching lug > 3
mm
Error code 11 16
The start-up locking protection for the roller sets has been
triggered 3 x in sequence.
Cause:
- Vehicle stands in roller set with the brake blocked or tighte-
ned.
- Defect at the touch roller inductive sensor: Inspect switching
distance and wiring.
Error code 11 40
No signal speed sensor driving roll left-hand side
Cause:
- Cable break
Error code 11 45
No signal speed sensor driving roll right-hand side
Cause:
- Cable break
To Next Page
