PTE511RK
n
PTE1115RK
n
PTEL511RK
n
PTEL1115RK Installation Guide
Page 12
WARNING Before servicing or cleaning unit,
switch power off at service panel and lock the service
disconnecting means to prevent power from being
switched on accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
Operation
To Turn Fan ON
Turn the control switch ON.
It is normal for this ventilation fan to take approximately
5-10 seconds to start running after it is turned on.
• Fan will run at the certified airflow rate if the boost
switch is ON.
• Fan will run at low speed continuous airflow rate if the
boost switch is OFF.
To Use Fan Time Delay Airflow Rate Change
1. Turn the control switch ON.
2. Turn the boost switch ON - fan will run at the certified
airflow rate.
3. When the boost switch is turned OFF, fan will
continue to run at the certified airflow rate until the
user-adjustable time delay has elapsed, and then will
automatically change to the low speed continuous
airflow rate.
To Set the Low Speed Continuous Airflow Rate*
Using a small, flat-blade screwdriver, carefully rotate the
CONTINUOUS RUN adjustment until the arrow points to
the desired airflow rate.
To Set the User-Adjustable Time Delay*
Using a small, flat-blade screwdriver, carefully rotate the
TIME adjustment until the arrow points to the desired time
delay, shown in minutes.
* The user-adjustable controls are located in one corner
of the Fan Housing, behind the Grille.
To Turn Fan OFF
Turn the control switch OFF (sold separately).
Lighting
Fan/light models are equipped with a main task light
and a night light. The fan and task light can be operated
independently using separate switches. The night light
automatically turns on when the room is dark. There is a
switch on the underside of the grille to deactivate the night
light.
Optional motion (PEM) or humidity sensing (PES)
modules (sold separately)
PTE511RK/PTEL511RK User-adjustable controls
PTE1115RK/PTEL1115RK User-adjustable controls
90º
sensor
10 ft.
PEM Range
PES Range
P2RW P3RW
To Next Page
Loading...
