Press a preset button (Ex: “rice”). The main display will show the default time
for this preset (Ex: 00:10). The digits to the right of the colon (“:”) display the
minutes and the digits left of the colon display the hours. On the main panel,
an LED bar will light up to indicate that the preset is on “normal” mode,
which is the default.
To begin cooking, close the lid, then press the “start/stop” button.
See “hours/minutes” and “texture” sections for instructions on adjusting
the time.
1
2
3
Follow these simple steps for each preset. On this example P0:10 is the default
pressure time. The pressure time will vary depending on the preset you choose.
Example:
PRESET GUIDE
Default Time
Texture
(minutes)
Time
(minutes & hours)
Presets &
Functions
Hrs:Min Less Normal More Min.* Max
Rice 00:10 00:07 00:10 00:13 00:01 01:40
Multi Grain 00:27 00:22 00:27 00:32 00:01 01:40
Soup 00:15 00:10 00:15 00:20 00:01 01:40
Meat/Stew 00:40 00:20 00:40 00:50 00:01 01:40
Poultry 00:20 00:15 00:20 00:25 00:01 01:40
Beans 00:20 00:15 00:20 00:25 00:01 01:40
Fish 00:08 00:06 00:08 00:10 00:01 01:40
Steam/Veggies 00:05 00:03 00:05 00:07 00:01 01:40
Potatoes 00:06 00:04 00:06 00:10 00:01 01:40
Bake 00:40 00:30 00:40 00:50 00:01 01:40
Canning 00:20 00:01 01:40
Delay 00:05 24:00
Warm 04:00 01:00 24:00
Sear 00:05 00:01 00:20
Slow Cook 04:00 02:00 09:00
*Minimum Time
The NuWave Nutri-Pot Digital Pressure Cooker is programmed to a set pressure of
70kPa. kPa as a unit of pressure measurement, is widely used throughout the
world instead of the “Pounds per Square Inch, (PSI)” method. kPa to PSI
ratio is approximately 7kPa to 1PSI.For example: 2PSI is equal to 14kPa.
To Next Page
Loading...
