NuWave PIC DOUBLE 30601 - Basic Functions; To Start Cooking; Setting the Clock

10 | nuwavenow.com
BASIC FUNCTIONS
Preset Temperatures
Press Button Temperature Panel Display Examples
Low 100°F 100F Warm
Med/Low 175°F 175F Simmer
Med 275°F 275F Steam
Med/High 375°F 375F Stir/Deep-Fry
High 425°F 425F Boil/Saute
Max/Sear 575°F SEAR Sear
Display temperature represents temperature of 1.5L of oil in the Nuwave 3.5-quart Stainless-steel Pot.
The thermometer location for test is the origin (middle) of the Pot with an equidistant length between the
pot base and top of the oil. The minimum is 100F while the maximum temperature reaches 575F.
To Start Cooking
There are several ways to begin cooking with your Nuwave
®
PIC Double with the default
cooking temperature and time being Max/Sear (575˚F) for 1 hour:
• Select the temperature (Low–Max/Sear), then press Start.
• Press Cook Temp, then press Start.
• Press Cook Temp. “Temp” will blink and the default “575F” will be displayed. Set the
cooking temperature using the numeric touchpad and press Start.
• Press Cook Time. “Time” will blink and “00:00” will be displayed. Set the cooking time
using the numeric touchpad and press Start.
• Set the temperature and time using the numeric touchpad, then press Start.
The unit will automatically stop cooking once time has expired and beep three times to
alert users. The display will always show the current temperature during the cooking cycle.
To display time lapse, press Cook Time while cooking.
NOTE: After 3 seconds, the display will revert to the cooking temperature. Each plate must
be set separately.
Setting the Clock
1. Press Clock. “CLOCK” will ash on LED display, “AM” will light, and “00:00” will be
displayed.
2. Enter digits to match the current time.
• For example: 1:25 would be entered by pressing “1, 2, 5”.
3. Once entered, the time will be set to “AM” by default.
4. To change over to “PM”, press am/pm.
5. Press Clock again to set. “CLOCK” will stop ashing
• End Time feature will not work unless the clock is set.
• If the unit is cut from its power supply or turned off,
the clock must be reprogrammed.
Start