NuWave PIC DOUBLE 30601 - Troubleshooting and Alerts

16 | nuwavenow.com
CARE & MAINTENANCE
Error Message: Solution(s):
E1
An E1 reading typically means the PIC Double does not detect
cookware on its surface. This can occur for one of two reasons:
1. The induction coils contained within the PIC Double will only
work when they are in direct contact with a piece of cookware.
To maintain your appliance’s effectiveness, always ensure that
it rests on a flat surface and that contact is consistent with your
cookware.
2. An E1 message may also occur if the chosen cookware is not
induction-ready.
E2 The PIC is malfunctioning. Contact Customer Service.
E3 The PIC’s voltage is too low. Minimum = 85 volts
E4 The PIC’s voltage is too high. Maximum = 144 volts
E5 The PIC is malfunctioning. Contact Customer Service.
E6 The PIC is malfunctioning. Contact Customer Service.
E7
Overheating, or air ventilation is obstructed. If internal temperature
exceeds 230F, operation will cease, and the PIC will beep. Press
Pause/Clear twice. Wait for the PIC to cool.
E8
Overheating, if PIC exceeds a temperature 20F higher than Sear,
the appliance will turn off. Contact Customer Service.
E9 The PIC is malfunctioning. Contact Customer Service.
Contact Customer Service at support@Nuwavenow.com.
After Removing
Cookware:
Beep
Sound:
Display: Reference:
Initial 1 Beep
Temperature or time
displays and “F” or
“C” or “:” flashes
within 10 seconds.
Return the cookware to the PIC
Double. Cooking will automatically
resume.
< 10 seconds None
11- 70 seconds Yes E1
If an error is displayed, return the
cookware to the PIC Double and
press Start to resume cooking.
After 70 seconds None 0
Cooking stops. Choose desired
temperature setting and press Start
to resume cooking.
TROUBLESHOOTING GUIDE
• When any error messages are displayed, the PIC will beep at least once.
• The fan will run up to a maximum of 60 seconds after pressing Pause/Clear or when
cooking has stopped. Press Start within 45 minutes to resume cooking. After that, it
will turn off if no buttons are pressed, displaying “0” when the program clears.