nuwavenow.com | 11
Setting Cooking Temperature
The Unit cooking temperature defaults to
Max/Sear (575˚F).There are two ways of
setting it:
1. Press Low–Max/Sear. The "TEMP"
indicator will flash and the temperature
range will appear on the display panel.
Then press Start.
2. Press Cook Temp. The "TEMP"
indicator will ash and "575F" will be
displayed. Set the desired cooking
temperature with the numeric touchpad.
If a number not ending in “5” or
“0” is entered, the PIC Double will
automatically set itself to the nearest
temperature ending in a “5” or “0”. For
example, when you press 2, 2, 2 for
cooking at 222˚F, the LED display will
read “220F” Then press Start.
• To raise or lower the temperature
in 5°F increments, press + and –
until the desired temperature is
displayed. Pressing and holding
these keys will speed up the
adjustment.
• Refer to the chart below for preset
temperatures. The minimum preset
temperature is 100°F, while the
maximum temperature is 575°F.
The desired cooking temperature
can be set by using the numeric
touchpad.
Temperature Format: ºF to ºC
The unit defaults to degrees Fahrenheit
for the cooking temperature, with “F”
appearing on the display panel. To switch
to Celsius(C), press Cook Temp and Cook
Time simultaneously. Repeat this to switch
back again.
To close the F/C conversion process, press
Pause/Clear until “0” or the current time
appears on the LED screen.
Setting the Cooking Time
1. Press Cook Time. “TIME” will ash
and “01:00” will be displayed.
2. Enter the time in hours and minutes
using the numeric touchpad.
• For example, 1 hour and 30
minutes would be entered by
pressing 1,3,0. The display panel
will show “1:30”.
• The time can be adjusted in
1-minute increments by pressing
– or +. Hold them to speed up the
adjustment.
• To check the time while cooking,
press Cook Time. The PIC will
revert to the temperature in 3
seconds.
• If the required time is in minutes,
you only need to enter one or two
numbers.
• For example, for 5 minutes, enter
5; for 46 minutes, enter 4, 6.
BASIC FUNCTIONS
3. If the number needs to be corrected,
clear the entry by pressing 0 until you
see “0:00” on the LED display.
• The blinking “TIME” indicates that
the time can be adjusted.
• The maximum programmable time
is 99 hours and 60 minutes.
• The display shows hours and
minutes, but not seconds.
The Pause/Clear Function
To interrupt cooking time, press Pause/
Clear once. This will pause the unit
regardless of cooking stage.
The temperature will remain listed in the
display panel for 45 minutes while the “F”
(or “C”) flashes. Settings may be adjusted
while cooking is paused.
To resume cooking, press Start.
To clear the cooking mode or display while
the PIC Double is in operation, press
Pause/Clear twice. The display will be
fully cleared and “0” will appear.
To Next Page
Loading...
