12 •
NuWave
®
PIC
®
Titanium Complete Cookbook
Directions for the Display Panel
Wattage Function:
The default wattage of the PIC Titanium is 1800 watts. To change the cooktop’s wattage, press “Watts”
once. The red light will illuminate above “600” indicating that the PIC Titanium is now set to 600 watts.
Press “Watts” once more and the red light above “900” will illuminate, indicating the PIC Titanium is
now set to 900 watts. Press “Watts” again and the red light above “1800” will illuminate, indicating that
the PIC Titanium is now set to the default 1800 watts.
Easy Start:
The NuWave PIC Titanium is preset to cook on Med/High (375°F) for 1 hour. To begin
cooking, press “Start” button, after placing an induction-ready pot on the surface. If cooking at a
power level other than “Med/High,” press “Low,” “Max/Sear” or press the “-” or “+” buttons to
increase or decrease temperature in 5°F increments. See the Panel Display Chart on the bottom
of this page for more details.
Control Panel:
“0” should appear when program is clear or power is on.
To Start Cooking:
There are several ways to begin cooking with your NuWave PIC Titanium :
• Press “Start.” Default temperature is 375°F and 1 hour cooking.
• Set temperature and press “Start.” Default is 1 hour cooking.
• Set cooking time and press “Start.” Default temperature is 375°F.
• Set temperature and time, then press “Start.”
The NuWave PIC Titanium will automatically stop cooking once time has expired and a “beep” sound
will alert users. The display will always show current temperature during the cooking cycle. To display
time lapse, press “Time” and a countdown will appear, marking the duration before the cycle or stage
is complete.
Setting Temperature:
This appliance is preset to cook on Med/High (375°F). To reset, press the desired temperature key
then press “Start.” The temperature range will appear on the display panel. To raise or lower the
temperature in 5°F increments, press the “+” or “-” buttons until desired temperature is displayed.
Refer to chart below for preset temperatures. The minimum is 100°F while the maximum temperature
reaches 575°F.
NOTE: Display temperature represents the center temperature of 1.5L of oil in the NuWave 3.5-quart
Stainless Steel Pot. Thermometer location for test at the origin (middle) of the NuWave 3.5-quart
Stainless Steel Pot and an equidistant length between the pot base and top of the oil.
F° to C°: The NuWave PIC Titanium’s LED screen is defaulted to display cooking temperature in
Fahrenheit(F). To switch the display to Celsius(C), press the “Prog” button, followed by “-”. Press
“-” again to convert to Celsius. To return to Fahrenheit, press “-” once more. To close out of the F/C
conversion option, press the “Pause/Clear” button until a “0” appears on the unit’s screen.
100°F (38°C)
175°F (79°C)
275°F (135°C)
375°F (191°C)
425°F (218°C)
575°F (302°C)
Press Button Range Temperature Examples
Low
Med/Low
Med
Med/High
High
Max/Sear
Warm
Simmer
Steam
Stir/Deep Fry
Boil/Saute
Sear
100F / 38C
175F / 79C
275F / 135C
375F / 191C
425F / 218C
SEAR
Panel Display
Low-Max/Sear
Program
Time Wattage
Wattage
Indicator
Decrease
LED
Display
Increase
Pause/Clear
Start
To Next Page
Loading...
