Need help?Do you have a question about the nux Booster and is the answer not in the manual?
General| Brand | nux |
|---|---|
| Model | Booster |
| Category | Music Pedal |
| Language | English |
Connects the 9V DC/300 mA power supply with center negative.
Connects pedal output to guitar amplifier or other effects unit.
Lights up when the pedal is enabled.
Foot switch used to turn effect on/off.
Connects pedal input to guitar or other effects unit.
Input impedance is 1M Ohms.
Output impedance is 10K Ohms.
Requires external AC adaptor, 9V DC regulated minimum 300mA.
Controls the amount of overdrive.
Controls the level of the signal.
Controls the amount of high frequency.
Delivers warm, natural tube overdrive sound with true bypass.
Controls the amount of overdrive.
Controls the level of the signal.
Controls the amount of high frequency.
Provides warm and clean overdrive sound with true bypass.
Adjusts the delay time.
Adjusts mix between dry signal and effect sound.
Adjusts delay feedback for repeats.
Enters TAP mode to adjust delay speed with footswitch.
Features classical digital delay effect, 1-second delay, true bypass.
Adjusts the volume of reverb.
Provides full reverb effect, classic hall sound, and true bypass.
Controls the volume level for loop playback.
Provides a quick guide to SOS looper operations.
Instructions for recording a loop with the SOS looper.
How to overdub new riffs onto an existing loop.
Instructions to undo or redo the last recorded loop segment.
Controls the amount of low frequency.
Controls the amount of overdrive.
Controls the amount of high frequency.
Increases volume without colored sound, features two-band EQ.
Varies the sweep rate of the effect.
Adjusts mix between dry signal and effect sound.
Controls the amount of sweep deviation.
Provides warm analog chorus effect with true bypass.
Adjusts the compression ratio.
Sets the attack time of compression effect.
Controls the level of the signal.
Features a fully analog circuit with a broad adjustable range.
Controls the amount of high frequency.
Adjusts the amount of distortion.
Controls the level of the signal.
Provides classic distortion tone with a 2-stage design.
Adjusts speed of phase effect.
Adjusts mix between dry signal and effect sound.
Controls the amount of intensity of effect.
Features warm analog phase effect with true bypass.
Adjust sweep rate of VIBE effect.
Controls the level of the signal.
Controls the amount of sweep deviation.
Analog rotary speaker effect with 4-stage phase simulation.
Adjust sweep rate of VIBRATO effect.
Sets the attack time of vibrato effect.
Controls the intensity of the VIBRATO effect.
Controls pedal on/off and effect engagement modes.
Features traditional vibrato effect and smart footswitch.
To Next Page
