nux Cerberus User Manual

UsingtheEffectsUsing the Effects
SPR (Spring Reverb)
This models a spring reverb inside a guitar amp. Use the
level knob to adjust the mix rao of the reverb sound. Use
the decay knob to adjust the reverb me.
PLA (Plate Reverb)
This is a plate reverb that contains a brightness tone and
natural reverb sound.
HAL (Hall Reverb)
This models a rather large hall and preserves the natural
characteriscs of guitar sound. Excellent for a discrete
reverb with long reverb me.
Delay/Reverb module allows you to choose among three
different signal roungs. A roung defines how the signal
runs through the units.
Making Global Settings
Serial Roung 1 Serial Roung 2 Parallel Roung
Delay
Reverb
Delay
Reverb
Delay
Reverb
Serial Roung 1:
The signal is going through the reverb secon first and
then to the delay secon.
Serial Roung 2:
The signal is going through the delay secon first and then
to the reverb secon.
Parallel Roung:
The signal is processed in parallel by the two secons, and
they provide their owner characteriscs.
Sengs that are shared by the enre Cerberus are called
“Global sengs.” They are not stored as a part of each
preset.
CAB. (Cabinet simulation)
Cabinet simulaon provide a direct interface of the
Cerberus’s output to a mixing console or headphones.
There are two ways to enable the cabinet simulaon:
1. Connecng headphones to phones jack will enable the
cabinet simulaon automacally.
2. Press CAB buon to enable the cabinet simulaon and
“CAB” appears in the display. Only the OUTPUT2 of the
Cerberus engage cab simulaon. You can sll connect
OUTPUT1 to guitar amplifier for monitor.
KILL DRY
With the switch in ON posion, no clean signal passes
through the Cerberus. “NOD” appears in the display. This is
the seng to use if you connect the unit in a parallel loop
or in an aux send/return on a mix.
LIFT/GND switch
Normally, you can set this switch to the GND posion.
If you’ve connected the EXT LOOP jacks to an amp, a
ground loop may occur, producing noise. If this occurs,
you may be able to eliminate the noise by moving this
switch to the LIFT posion.
I/O LEVEL switch
Normally, you can set this switch to the -10dB posion
when you are using guitar amp as input. If you’ve
connected the output to mixer or amp’s send/return
loop, moving this switch to the +4dB.
1312

nux Cerberus Specifications

General

Type	Multi-effects pedal
MIDI	No
Analog Drive	Yes
Amp Models	No
Effects	Distortion, Modulation, Delay, Reverb
Inputs	1 x 1/4" (instrument)
Outputs	1 x 1/4" Headphones
Power	9V DC power supply
USB	Yes, for firmware updates
Impulse Response (IR) Loader	Yes
Footswitches	4 footswitches
Expression Pedal	Yes
Looper	Yes
Cabinet Models	No
Display	LED
Presets	128 user presets